 |
|
STREETSIDE CABINETS General All the following street cabinets are manufactured in marine quality aluminium. They are built to exacting standards for use in high security or harsh environmental applications The cabinets are supplied as standard with heavy-duty stainless steel latches and there is provision for secondary security locks. Double skin pitched roof bolted to body. Alternate roof styles can be provided on request including flat, high pitched or steep slope versions to dissuade climbing or sitting on cabinet. The bolted construction enables the roof style to be changed retrospectively where conditions dictate. Fully welded one-piece construction in 3mm thick material. In the event of severe accident damage, the body can be changed without disconnecting the cross-connection equipment. 3mm hot-dip galvanised steel base. Separated from body by full flange rubber gasket to prevent galvanic corrosion. Stainless steel latches with nylon pawls operated by heavy-duty tee-bar keys in a variety of vandal resistant standard shapes. Additional customised styles are available. O type ring seals within the latch body ensure lifetime lubrication and IP65 performance. Latches are tested to withstand a test requirement of 50NM. Provision is made for secondary security locks to be fitted on assembly or retrospectively by the end user with removable blanking covers fitted to standard profile cut-outs. Fitment by end user ensures controlled access. Security dogs on the hinge side of the door prevent the door being removed even if the hinges are forced. Finally a hasp is provided for an external padlock for securing door to base if required. The side ventilation units are protected against ingress of inflammable or corrosive liquids by inner boxes. Cabinets can operate in sealed or ventilated mode. In ventilated mode, convection currents draw fresh air in through louvers at sides of cabinet forcing warm air out through concealed vents above the doors. Side vents are protected by insect-proof mesh. Changing between sealed and ventilated modes can be done easily without additional components. The cabinet roof has a double skin and air gap to help protect against solar gain. This "double glazing" also helps to reduce condensation. Pre-treatment by chemical etching followed by powder coating with polyester material in customer’s choice of colour (standard is green). Multi-colour finishes and silk screened or embossed logos are available on request. The gloss finish enables graffiti to be removed using mild solvents or mild abrasive compounds. Damage can be touched up using brush or aerosol techniques. Repainting is best achieved using two pack polyurethane compounds although gloss paint can be used. For the 1200 pair and 19” Swing Rack a single door with heavy duty hinges is supplied, whereas for the No6/No7 a similar double door system is supplied. Opening to 180 degrees, doors can be lifted off for additional access. Door stays retain the doors at 90 and 135 degrees. Replaceable synthetic rubber car boot type seals are used throughout. Equipment Mounting (Backboards) Cabinets are supplied as standard with fixings to allow installation of Krone, MS2 or Strips Cross Connection. Alternatively the cabinets can be supplied with stainless steel, aluminum, marine ply or chipboard backboards. Star punched or custom punched units are available in all three of the metal versions. Optional gauge plates can be provided for mounting pressure gauges and transducers. The 19” Swing Frame has additional flexibility for equipment mounting; a marine ply backboard (800mm high x 650mm wide) is also supplied.
|
